1. Turn cartridge slowly to the left, about 1/4 turn, until it stops (when arrows line up). At this position, both inlet and outlet ports are closed and water pressure has been relieved.
2. Pull used cartridge straight down and discard.
Note: There may be a small amount of residual water drainage after pressure is relieved and during cartridge removal.
3. Remove sanitary cap from top of new cartridge. Moisten o-ring with water and push new cartridge into filter head. Turn cartridge 1/4 turn to the right until it stops. Top surface of cartridge will become flush with bottom of the head when fully engaged. The label should be facing forward.
4. Open downstream valve (if installed) and flush new filter cartridge in accordance with Performance Data Sheet expelling Tany trapped air and carbon fines. Water may run cloudy with air but will quickly clear.
Caution: Do not use with water that is microbiologically unsafe or of unknown quality without adequate disinfection before or after the system. To ensure optimal performance and hygiene and to prevent build up of contaminants, we recommend Aqua Blue H20 filters are not used any longer than 12 month.
Filter to effectively reduce the sediment, chlorine, taste & odours.
Lead at pH 6.5/ Lead at pH 8.5/ Lindane/ Mercury at pH 6.5/ Mercury at pH 8.5
Particulates (Class I)
Chemical and Mechanical ReductionTested and Certified by NSF International against NSF/ANSI Standards 42 for the reduction of Chlorine Taste and Odour.
Important: Do not use with water that is microbiologically unsafe or of unknown quality without adequate disinfection before or after the system. The contaminants or other substances removed or reduced by the water filter device are not necessarily in your water.
BEST PRICE GUARANTEE
We aim to provide you with the best price available in Australia!
If you are not 100% satisfied with your purchase we offer a full refund or replacement.