Apex Filtamate FMP 350 KPA Pressure Limiting Valve (PLV) plastic with 1/4" tube ports

FMP350

New product

Apex Filtamate 350 KPA Pressure Limiting Valve (PLV) plastic with 1/4" tube ports

FMP350 AUSTRALIAN  MADE  GENUINE  PRESSURE LIMITING   VALVE

More details

Each: $54 tax incl.

More info

Apex Filtamate FMP 350 KPA

Pressure Limiting Valve (PLV)

Plastic with 1/4" tube ports

FMP350 AUSTRALIAN MADE

GENUINE PRESSURE LIMITING VALVE

Product Description

A Wells certified Apex Filtamate Pressure Limiting Valve (PLV) rated to 350KPA with 1/4" tube ports is a must for any under bench water filter system. Not having one installed could mean that if you ever did have to claim insurance on damage caused by a burst water filter system may be denied due to the lack of Certified pressure limiting protection installed.

All complete under bench water filtration systems sold by URWater include either a 350KPA or 600KPA pressure limiting valve to protect the water filter system from extreme water pressure events which could occur in the town water pipes. If your system does not already have a PLV then you should 

  • Integral dual check valves help prevent backflow

  • FiltaMate resists water hammer and limits water pressure to filters thus avoiding costly water damage.

  • FMP supplied with fixing clip and screw.

Standards

  • Complies with NZS 4608:1992

  • Australian Watermark Approval AS1357.2 Lic. 02596

Installation_des.png

  • Installation must be carried out by a Qualified Plumber

  • All pipe work must be flushed prior to installation

  • Do NOT apply heat near valve during installation

  • Must be fitted downstream of approved isolating valve

  • Must be installed in the direction as indicated by the flow arrow

  • Must be protected by a line strainer - See Specifications tab

  • Must be installed according to local regulations

  • May be fitted in any orientation

  • Warranty is limited to any fault found in a valve due to poor workmanship or materials that is returned to Apex Valves Ltd within 2 years from the date of manufacture

  • If thermal expansion (due to heating or cooling) or back pressure can occur downstream, an expansion valve must be fitted to relieve the excess pressure build up

Plastic tube: Polyethylene, Nylon and Polyurethane conforming to the tolerances shown below. Do not use soft or thin walled pipe. It is essential that the outside diameter is free from score marks and that the tube be deburred before inserting into the cartridge.

Tube Tolerances Imperial sizes: 1/4 - 1/2"

Metric Sizes: 6 - 22mm Tolerances: + 0.001/ - 0.004"

Tolerances: + 0.05/ - 0.10

  • Inlet - ¼" John Guest connector

  • Outlet - ¼" John Guest connector

  • Length 98mm

  • Check Valve Dual

  • Flow Rate - 14 L/min at 700 kPa [100psi] inlet pressure

  • Pressure Ratio - 10:1 (for every 10 kPa [1.5psi] increase in inlet pressure above 1000 kPa [150psi], the outlet pressure will increase by 1 kPa [0.145psi]).

  • Outlet Pressures - 350 and 600 kPa [50, 60 and 85psi] +/- 10% @ 1000 kPa

  • [150psi] inlet pressure.

  • Maximum inlet pressure - 1600 kPa [230psi]

  • Maximum temperature - 40°C [105°F]

  • Minimum temperature - 1°C

Reviews

Path: > > > Apex Filtamate FMP 350 KPA Pressure Limiting Valve (PLV) plastic with 1/4" tube ports

Related Products